Open-cell mullite ceramic foams derived from porous geopolymer precursors with tailored porosity

• Published in: Journal of Advanced Ceramics
• Main Authors: Jiahuan Shao, Chengying Bai, Xinyu Li, Kun Yang, Ting Zheng, Yingjie Qiao, Lili Zhang, Hongqiang Li, Paolo Colombo
• Format: Article
• Language: English
• Published: Tsinghua University Press 2023-02-01
• Subjects: porous mullite ceramic; porosity; porous geopolymer precursor; direct foaming; nanophase strengthening
• Online Access: https://www.sciopen.com/article/10.26599/JAC.2023.9220682

Porous geopolymer precursors were firstly prepared by the direct foaming method using bauxite, fly ash (FA), and metakaolin (MK) as raw materials, and porous mullite ceramics were prepared after ammonium ion exchange and then high-temperature sintering. The effects of chemical foaming agent concentration, ion-exchange time, and sintering temperature on porous geopolymer-derived mullite ceramics were studied, and the optimal preparation parameters were found. Studies have shown that the concentration of blowing agent had great influence on open porosity (q) and porosity and cell size distributions of geopolymer samples, which in turn affected their compressive strength (σ). Duration of the ion exchange had no obvious effect on the sintered samples, and the amount of mullite phase increased with the increase in the sintering temperature. Mullite foams, possessing an open-celled porous structure, closely resembling that of the starting porous geopolymers produced by directly foaming, were obtained by firing at high temperatures. Stable mullite (3Al2O3·2SiO2) ceramic foams with total porosity (ε) of 83.52 vol%, high open porosity of 83.23 vol%, and compressive strength of 1.72 MPa were produced after sintering at 1400 ℃ for 2 h in air without adding any sintering additives using commercial MK, bauxite, and FA as raw materials.