Retention of Silica Nanoparticles in a Lab-Scale Membrane Bioreactor: Implications for Process Performance and Membrane Fouling

• Main Authors: Mark Larracas Sibag, Soo Mi Lee, Hee Jun Kim, Jinwoo Cho
• Format: Article
• Language: English
• Published: MDPI AG 2016-07-01
• Series: Water
• Subjects: silica nanoparticles; membrane bioreactor; membrane fouling; activated sludge respiration inhibition
• Online Access: http://www.mdpi.com/2073-4441/8/7/277

In conventional activated sludge (CAS) involving aerobic biological processes, the retention of silica nanoparticles (SiO2 NPs) has no detrimental effect on chemical oxygen demand (COD) and ammonia nitrogen (NH3–N) removal. However, for the membrane bioreactor (MBR) system, which is also based on the activated sludge process in addition to the membrane separation process, it has implications not only on the process performance but also on membrane fouling. To investigate these two implications in lab-scale experiments, we continuously operated a control MBR and two experimental MBRs, in which the 28 nm SiO2 NPs and 144 nm SiO2 NPs were added separately to the influent at a final concentration of 100 mg/L. Although the retention of SiO2 NPs in the MBR, as confirmed by dynamic light scattering (DLS) analysis, did not compromise the COD and NH3–N removal, it resulted in substantial increases in the transmembrane pressure (TMP) suggesting the onset of membrane fouling. Analyses by batch-dead end filtration revealed the same fouling trend as observed during the continuous MBR experiments; membrane fouling is aggravated in the presence of SiO2 NPs. This was evident from permeate flux decline of between 30% and 74% at very low TMP (5 kPa) and the further increases in the total resistance.