A development of the method of the control signal formation for the hot plate mill automation systems to improve the flatness of the finish plate
This article describes how to control of the hot plate mill automation system to improve the quality metrics if the final strip. Based on the data of the modern hot rolling mills the classification of the cage equipment was designed. Depending on the degree of influence on the magnitude of reduction...
| Main Authors: | , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
EDP Sciences
2016-01-01
|
| Series: | MATEC Web of Conferences |
| Online Access: | http://dx.doi.org/10.1051/matecconf/20164504001 |
| Summary: | This article describes how to control of the hot plate mill automation system to improve the quality metrics if the final strip. Based on the data of the modern hot rolling mills the classification of the cage equipment was designed. Depending on the degree of influence on the magnitude of reduction, the equipment was divided into categories. The functioning of every system including the main and the vertical cages was described. The conditions of electrical and hydraulic mechanisms was marked. The developed algorithm allows to improve defects based on the finite number of the thickness measurements given by special non-contact sensors. The example of regulators signals calculating was shown. The result of the algorithm operating was illustrated. |
|---|---|
| ISSN: | 2261-236X |