Analysis of Zones Created with Waterjet Cutting of AISI 316 L Corrosion Resistant Steel

Analysis of Zones Created with Waterjet Cutting of AISI 316 L Corrosion Resistant Steel

This work deals with the quality of machined surface obtained with waterjet cutting (WJC) technology, regarding the influence of selected dynamic parameters (traverse speed, abrasive mass flow rate and pressure) on the quality of machined surface. Examination presented in the work was carried out on...

Full description

Bibliographic Details
Main Authors: Valnea Starčević, Ivan Samardžić, Miroslav Duspara
Format: Article
Language:English
Published: Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek 2018-01-01
Series:Tehnički Vjesnik
Subjects:
analysis of variance
central composite design
cutting parameters
surface quality
waterjet cutting
Online Access:https://hrcak.srce.hr/file/293224
Description
Summary:This work deals with the quality of machined surface obtained with waterjet cutting (WJC) technology, regarding the influence of selected dynamic parameters (traverse speed, abrasive mass flow rate and pressure) on the quality of machined surface. Examination presented in the work was carried out on specimens made from AISI 316L corrosion resistant steel and measured with portable surface roughness tester. Results obtained by experiment were analyzed with licensed version of software for statistical analysis Design Expert 10.
ISSN:1330-3651
1848-6339

Similar Items