Design of Anchorage Zones of Pretensioned Concrete Girders: A Comparison of Nonlinear 3D FEM Results with Measurements on a Full Scale Beam

• Main Authors: Wouter De Corte, Kizzy Van Meirvenne, Veerle Boel, Luc Taerwe
• Format: Article
• Language: English
• Published: MDPI AG 2020-11-01
• Series: Applied Sciences
• Subjects: pretensioned girders; anchorage zones; nonlinear FEM; ABAQUS
• Online Access: https://www.mdpi.com/2076-3417/10/22/8221

Pretensioned concrete beams are widely used for constructing large load-bearing structures and bridging long spans. Crack formation may occur in the end zones of these elements due to tensile splitting, spalling and bursting actions. Investigation of these zones is typically done by means of analytical methods, strut and tie modelling, 2D linear or nonlinear analysis, or full 3D nonlinear analysis. Especially challenging in this last approach is the modelling of the force transfer from the strands to the surrounding concrete as it strongly influences the magnitude of the tensile stresses. This paper presents a 3D nonlinear analysis of the anchorage zone of a pretensioned girder, and a comparison with experimental results (mechanical strain measurements, embedded strain gauges). Material modelling, steel-concrete interaction properties, as well as convergence problems are addressed systematically. The comparison indicates that a good agreement is found, both for concrete and rebar strains, and that a friction coefficient of 0.7 can be adopted, although the results for values from 0.5 to 0.9 do not differ that much. The results demonstrate that a 3D nonlinear analysis provides an excellent insight in the behavior of the end zones of pretensioned girders which opens perspectives for an optimization of the end zone design based on this type of analysis.