Industrial Ceramic Blocks for Buildings: Clay Characterization and Drying Experimental Study

• Main Authors: A.M. Vasconcelos da Silva, J.M.P.Q. Delgado, A.S. Guimarães, W.M.P. Barbosa de Lima, R. Soares Gomez, R. Pereira de Farias, E. Santana de Lima, A.G. Barbosa de Lima
• Format: Article
• Language: English
• Published: MDPI AG 2020-06-01
• Series: Energies
• Subjects: ceramic blocks; clay; mass; heat; dimensional variation
• Online Access: https://www.mdpi.com/1996-1073/13/11/2834

The conformation of a ceramic piece follows the steps of preparing the raw material, molding, lamination, drying, and firing. Drying is a thermodynamic process of heat and mass transfer, with dimensional variations of the product that requires a large amount of energy. Ceramic materials when exposed to non-uniform drying may suffer cracks and deformations, reducing their post-drying quality. Thus, this work aimed to study the drying of industrial ceramic blocks in an oven with forced air circulation. Experiments were carried out to characterize the clay and drying of the ceramic block at temperatures ranging from 50 °C to 100 °C. Results of the chemical, mineralogical, granulometric, differential thermal, and thermogravimetric analysis of the clay, and heating kinetics, mass loss, and dimensional variation of the industrial ceramic block are presented and analyzed in detail. It was found that the clay is basically composed of silica and alumina (≈ 80.96%), with an average particle diameter of 13.36 μm. The study proved that drying at high temperature and low relative humidity of the air generates high rates of mass loss, heating, and volumetric shrinkage in the ceramic product, and high thermo-hydraulic stresses, which cause the appearance and propagation of cracks, gaps, and cleavages, compromising the final quality of the product.