Changes of cytotoxicity of Ti-6Al-4V alloy made by DMLS technology as effect of the shot peening

• Main Authors: Remigiusz Żebrowski, Mariusz Walczak, Kazimierz Drozd, Mirosław Jerzy Jarosz
• Format: Article
• Language: English
• Published: Institute of Rural Health 2020-12-01
• Series: Annals of Agricultural and Environmental Medicine
• Subjects: neuroblastoma; cytotoxicity; titanium implant; shot peening; additive manufacturing
• Online Access: http://www.aaem.pl/Changes-of-cytotoxicity-of-Ti-6Al-4V-alloy-made-by-DMLS-technology-as-effect-of-the,116386,0,2.html
• ISSN: 1232-1966; 1898-2263

Objective The aim the study was to investigate the impact of the shot peening process on the condition of the surface layer and biological properties of titanium alloy produced by means of the Direct Metal Laser Sintering (DMLS) method. Material and Methods Specimens were prepared by the EOSINT M280 metal sintering laser system. The surfaces were subjected to the shot peening process using three different media, i.e. steel shot, nutshell granules and ceramic beads, after which they were subjected to profilometric analysis, scanning electron microscopic (SEM) observations and energy dispersive X-ray spectroscopy (EDS) tests, as well as to assessment of biological compatibility in terms of cytotoxicity (SH-SY5Y cell lines). Results The general results obtained from the tests indicate satisfactory biocompatibility of the examined surfaces and that the impact of the shot peening process on the titanium alloy cytotoxicity is acceptable. Conclusions The lowest cytotoxicity was demonstrated by the surfaces modified by ceramic beads than the nutshells and the biggest steel shot correspondingly. Moreover, the shot peening process carried out by means of CrNi steel and ceramic shot caused the reduction of surface roughness when, for the surface processing by means of nutshell granules, the increase of surface roughness was observed compared with the unmodified surface of titanium alloy samples.