| Summary: | Fretwork, as a decorating technique, can today be performed with modern means by laser or CNC routing, but the tool influence on the surface quality must be well understood for further optimization of the cutting parameters. The paper presents an experimental work for the determination of the influence of the cutting angle with respect to the grain on the surface quality of larch wood (<i>Larix decidua</i> Mill.) cut through by laser and CNC routing at different feed speeds. The research considered geometric fretwork patterns derived from triangle, where the cutting angles with respect to the wood grain were 0°, 15°, 30°, 45°, 60°, 75° and 90°. The feed speeds of the CNC routing were set for 2, 2.5, 3, 3.5 and 4 m/min. The surface quality was analyzed by a range of roughness, waviness and primary profile parameters combined with stereomicroscopic images. Although the principle of cutting and interaction with wood of the two processing tools, laser and CNC, is very different, the analysis with roughness parameters has revealed that the cutting angle with respect to the grain has an essential influence, whatever the cutting tool. The surface quality decreases with an increase in the feed speed of the CNC router and processing at 15° and 60° appears to be the worst option from all angle variants for both types of processing. Cutting by laser is melting wood in latewood areas resulting in a smoothing effect.
|
|---|
