Phase Transitions in the α–γ–β Spodumene Thermodynamic System and Impact of γ-Spodumene on the Efficiency of Lithium Extraction by Acid Leaching
Heat-treatment of spodumene concentrate at 1323 K (1050 °C) for 30 min in a rotary kiln yielded a successful decrepitation. Particle size decreased from 2 cm to less than 425 µm for 80% of the initial mass. X-ray analysis of both fractions did not reveal the presence of α-spodumene or γ-spodumene. T...
Main Authors: | , , , |
---|---|
Format: | Article |
Language: | English |
Published: |
MDPI AG
2020-06-01
|
Series: | Minerals |
Subjects: | |
Online Access: | https://www.mdpi.com/2075-163X/10/6/519 |
Summary: | Heat-treatment of spodumene concentrate at 1323 K (1050 °C) for 30 min in a rotary kiln yielded a successful decrepitation. Particle size decreased from 2 cm to less than 425 µm for 80% of the initial mass. X-ray analysis of both fractions did not reveal the presence of α-spodumene or γ-spodumene. The coarse fraction was ground to less than 425 µm with minimal mechanical energy and mixed with the finer fraction to perform lithium extraction. The lithium extraction efficiency reached 98 wt% without the need for flotation. Some aspects of the thermodynamic behavior of the spodumene system were assessed. Results show that metastable γ-spodumene may hinder the formation of β-spodumene at lower heat treatment temperatures. Some heat-treated samples presented non-negligible γ-spodumene content and lithium extraction efficiency decreases as the γ content increases. Finally, the assumed irreversibility of the transformations was studied by analyzing heat-treated samples following long controlled-storage periods. The results show that concentrate composition is not static over the studied time. This suggests that the β formation is not as irreversible as claimed. It is recommended to avoid long periods between heat-treatment and extraction to avoid the slow conversion of β-spodumene to other allotropes, which are less susceptible to lithium extraction. |
---|---|
ISSN: | 2075-163X |