INVESTIGATION OF CUTTING FORCE IN HARDENED STEEL TURNING
The paper presents results of the processing parameter effect, i.e. the magnitude of cutting speed and cutting force component feed in turning of hardened steel grades 45, 40X, 50X, CVH hardness 45..50 HRC with the help of the tool equipped with cutting ceramics EQA-60. The laboratory bench has bee...
Main Authors: | Mr. Alexander I. Pronin, Mr. Yevgeny B. Shchelkunov, Mr. Sergey V. Vinogradov, Ms. Marina Ye. Shchelkunova, Mr. Vladimir V. Mylnikov |
---|---|
Format: | Article |
Language: | Russian |
Published: |
Komsomolsk-na-Amure State Technical University
2016-12-01
|
Series: | Učenye Zapiski Komsomolʹskogo-na-Amure Gosudarstvennogo Tehničeskogo Universiteta |
Subjects: | |
Online Access: | http://www.uzknastu.ru/files/pdf/28/1/8.pdf |
Similar Items
-
Influence of Cutting Speed and Feed Rate on the Wear of an S-Type Mixed Ceramic Tool in Turning of AISI 4140 Hardened Steel
by: Jeferson H. W. Nicolodi, et al.
Published: (2019-01-01) -
Application of an Adaptive “Neuro-Fuzzy” Inference System in Modeling Cutting Temperature during Hard Turning
by: Borislav Savkovic, et al.
Published: (2019-09-01) -
Effect of Type of Cutting Tips on Cutting Forces in Turning
by: Polák Pavel, et al.
Published: (2014-10-01) -
Surface hardness prediction based on cutting parameters in turning of annealed AISI 1020 steel
by: Omar Jose Zurita Hurtado, et al.
Published: (2017-10-01) -
Monitoring and neural network modeling of cutting temperature during turning hard steel
by: Tarić Mirfad R., et al.
Published: (2018-01-01)