Friction and Material Modelling in Finite Element Simulation of Orthogonal Cutting
In the present paper the influence of the friction and material modelling on the results of the Finite Element simulations of machining is investigated. An orthogonal cutting model is proposed, which incorporates Coulomb’s friction law. The validity of this model is tested against similar experiment...
Main Authors: | A.P. Markopoulos, N.M. Vaxevanidis, D.E. Manolakos |
---|---|
Format: | Article |
Language: | English |
Published: |
University of Kragujevac
2015-12-01
|
Series: | Tribology in Industry |
Subjects: | |
Online Access: | http://www.tribology.fink.rs/journals/2015/2015-4/7.pdf |
Similar Items
-
Friction in Orthogonal Cutting Finite Elements Models with Large Negative Rake Angle
by: A.P. Markopoulos, et al.
Published: (2016-06-01) -
Surface Roughness Investigation and Stress Modeling by Finite Element on Orthogonal Cutting of Copper
by: Hussein Zein, et al.
Published: (2018-06-01) -
Finite Element Analysis of Orthogonal Cutting Forces in Machining AISI 1020 Steel Using a Carbide Tip Tool
by: Bashistakumar M., et al.
Published: (2018-11-01) -
Cutting forces and crater wear prediction in orthogonal cutting using two approaches of finite element modeling
by: Hatem A. Soliman, et al.
Published: (2020-10-01) -
Finite Element Modeling of Orthogonal Machining of Brittle Materials Using an Embedded Cohesive Element Mesh
by: Behrouz Takabi, et al.
Published: (2019-05-01)