A Kalman Filter Approach to Active Duct Noise Control Using TI TMS320C6713 DSP

• Main Authors: Chieh-Li Huang, 黃玠理
• Other Authors: 蕭俊祥
• Format: Others
• Language: zh-TW
• Published: 2008
• Online Access: http://ndltd.ncl.edu.tw/handle/h7hz4a

碩士 === 國立臺北科技大學 === 機電整合研究所 === 96 === In this paper a Kalman filter fitted in the feedback active noise control system is derived for suppressing duct noise. The secondary path of a duct noise system is modeled by an IIR filter, whereas the controller filter is modeled by an FIR filter. The secondary path dynamics is obtained by off-line system identification technique. The controller FIR filter is tuned on-line by the developed Kalman algorithm. Computer simulations show that Kalman algorithm outperforms the FXLMS algorithm in minimizing the duct noise, especially for broadband noise. To verify the effectiveness of the Kalman algorithm, experiments are conducted for duct noise suppression. A TI TMS320C6713 DSP is used for implementing the complex Kalman algorithm. While the Kalman algorithm and the FXLMS algorithm may have comparable performance is reducing pure-tone duct noise, noises with two-tone or more (even the broadband noise) can be shown experimentally to be reduced more by using the Kalman algorithm than the FXLMS algorithm. The experimental results indicated that up to 30dB and 20dB noise reduction was obtained for two-tone and three-tone noise respectively with the application of Kalman algorithm, while an average 3.3dB noise reduction for the broadband noise was observed. Finally, duct noise originated from a blower is used, the Kalman algorithm is shown to achieve a noise suppression of 7.5dB, better than the FXLMS algorithm does.