Study on minimizing warpage of injection molding for desktop plastic case
碩士 === 國立高雄應用科技大學 === 模具工程系 === 99 === The warpage of desktop computer case is not only caused by thin-wall injection and complex structures, but also the uneven thickness. Short-shot is caused by high flow ratio, however residual stress of high pressure also leads warpage. This research is focus on...
Main Authors: | Huang chih wei, 黃智維 |
---|---|
Other Authors: | Huang chung ching |
Format: | Others |
Language: | zh-TW |
Published: |
2011
|
Online Access: | http://ndltd.ncl.edu.tw/handle/33445751162779080801 |
Similar Items
-
The minimal warpage design in plastic injection molding
by: Yeh Ching-Min, et al.
Published: (2006) -
Minimizing Warpage of Plastic Injection Molding for a Motorcycle Carrier
by: Chin–Ming Tsai, et al.
Published: (2010) -
Minimizing Warpage of Plastic Injection Molding for a Blade of Wind Power Generator
by: Tuan-Sheng Hsu, et al.
Published: (2010) -
Study of Gradual-Thickness-Variation to Minimize the Warpage of Injection Molded and IMD Parts
by: Shih-Tsun Huang, et al.
Published: (2011) -
The CAE Warpage Analysis of Plastic InjectionMolding Parts
by: Wen-Pin Yang, et al.
Published: (2010)