An Investigation of the Wide-Bandgap GaP Material used for Silicon-Based Solar Cells

• Main Authors: Ching-Yao Pai, 白景堯
• Other Authors: Jyi-Tsong Lin
• Format: Others
• Language: zh-TW
• Published: 2012
• Online Access: http://ndltd.ncl.edu.tw/handle/99533999322888486790

碩士 === 國立中山大學 === 電機工程學系研究所 === 100 === In this thesis, we propose a new structure of GaP/a-Si:H/BulkSi solar cell in which the additional a-Si:H layer due to the concept of energy bandgap is used to improve the open-circuit voltage. As the a-Si:H doping concentration is increased, the upward bandgap bending is expected to be observed; hence, a high open-circuit voltage is obtained. But in this situation, the upward bandgap bending also hinders the carrier transport, leading a low short-circuit current density. It is worth noting that the proposed solar cell can have a high open-circuit voltage of 0.758 V. In addition, we carefully investigate the characteristics of wide-bandgap gallium phosphide (GaP) material used for silicon-based solar cells. According to the simulated results, the absorption of GaP is better than silicon with a wavelength below 450 nm. Also, the GaP/BulkSi solar cell is shown to have a lower reflectivity value than the conventional PN_BulkSi solar cell. Hence we can prove that the internal quantum efficiency and external quantum efficiency are improved accordingly. As a result, the short-circuit current density is increased about 10 %. In addition, the optimized parameters of a GaP/BulkSi solar cell are as follows: the short-circuit current density is 21.264 mA/cm2, the open-circuit voltage is 0.624 V, the fill factor is 82.4 %, the conversion efficiency is 11.236 %, respectively.