Partial Discharge Analysis of Stator Insulation at Arbitrary Voltage Waveform Stimulus
Partial discharge (PD) detection is a powerful tool to diagnose the defects and degradation in high voltage electrical insulation systems. It can be performed in both on-line and off-line conditions. Unlike the on-line PD measurement, the off-line PD test can be performed at other voltages or freque...
Main Author: | |
---|---|
Format: | Doctoral Thesis |
Language: | English |
Published: |
KTH, Elektroteknisk teori och konstruktion
2015
|
Online Access: | http://urn.kb.se/resolve?urn=urn:nbn:se:kth:diva-166807 http://nbn-resolving.de/urn:isbn:978-91-7595-548-3 |
Summary: | Partial discharge (PD) detection is a powerful tool to diagnose the defects and degradation in high voltage electrical insulation systems. It can be performed in both on-line and off-line conditions. Unlike the on-line PD measurement, the off-line PD test can be performed at other voltages or frequencies besides power-frequency (50 Hz or 60 Hz) sinusoidal voltage. The PD studies in this work were done with other types of voltage waveforms to initiate the discharge, aiming to obtain a better understanding of PD features and its physics, mainly focused on how the charges on the insulating surface affect the discharge process. In particular, this method was studied for application in the stator insulation of high-voltage rotating machines. Several types of arbitrary voltage waveforms have been explored, such as periodic negative step voltage, triangular voltage, trapezoidal voltage and ''square'' voltage. The PD measurements in this work can be summarized in two parts. One is the fundamental study of corona, surface and cavity discharges in the canonical test cells, using some common insulation materials such as polycarbonate and epoxy. The effect of different materials on corona discharge at periodic negative step voltage pulses was studied in the needle-plane geometry, in comparison with the corona discharge without the insulation material. The evolution of corona pulses shows that the PD repetition rate is strongly dependent on the charges deposited on the insulating surface, and the material properties such as conductivity have a significant effect on the charge decay process during the PD activities. Surface and cavity discharges were compared by the phase resolved PD patterns at several periodic voltage waveforms. The results indicate that the arbitrary voltage waveforms, particularly the square voltage, in off-line PD tests are a potential method for better identification of these two PD sources. The other part is the practical study for stator winding insulation materials, which consists of mica, epoxy resin and glass-fiber. Specific PD sources that are sphere-plane discharge and crossed-bar discharge based on the stator insulation were created in the laboratory, in order to imitate real insulation such as slot discharges and dielectric bounded cavities. The trapezoidal voltage waveform, including triangular and square voltages was mainly used. Varied ambient conditions such as relative humidity (RH) and temperature were introduced into this part. Slot discharge was modelled by placing a spherical metal electrode above the mica-epoxy insulating surface, leaving a small air gap where PD may occur. The effect of humidity on the sphere-plane discharge shows that a few big discharge pulses in dry air will turn into a larger number of small pulses in humid air probably due to the increasing surface conductivity in a higher humidity condition. Crossed-bar discharge which took place in the air gap between two mica-epoxy surfaces of the cured samples was studied, combined with the influence of the temperature. The variation of PD patterns shows that the effect of temperature on the PD behavior is mainly due to the decreasing PD inception voltage with the increasing temperature. === <p>QC 20150518</p> |
---|