Low-power silicon planar micro-calorimeter employing nanostructured catalyst

• Main Author: Lee, Siu Man
• Published: University of Warwick 2002
• Subjects: 681.25; TP Chemical technology
• Online Access: http://ethos.bl.uk/OrderDetails.do?uin=uk.bl.ethos.399509

This thesis describes the development of silicon planar micro-calorimetric gas sensors employing a nanostructured palladium (Pd) catalyst. Present commercial, bead-type calorimetric sensors have been manufactured for nearly forty years and are used in many applications, such as mining, water treatment and emergency services, with an estimated European market value of €221M by 2004. However, recent advances in both silicon micro-machining and nano materials have created the technologies necessary to transform the present labour-intensive fabrication process in to a new low-cost batch production. In addition, a reduction in power consumption, improved sensitivity and increased poisoning resistance of the sensor can also be achieved. Here, two generations of micro-calorimeter have been designed and fabricated comprising a silicon membrane structured micro-hotplate that can reach up to a temperature of 870'C without failure and an ultra-high surface area nanoporous Pd catalyst (about 20 m2/g), typically 25 run thick, deposited electrochemically on top of a gold electrode above the micro-heater. The exothermic reaction caused by the target gas (e.g. methane) interacting with the Pd catalyst results in an increase in the temperature and so resistance of the micro-heater. A Wheatstone bridge interface circuit is normally used to detect and measure the fractional resistance change. Full 3-D thermo-mechanical simulations have been performed employing experimental data in order to establish a simulation database for future developments. The differences between simulated and experimental results were found to be as low as 4.6%. The response of the sensors has been characterised in both continuous powering mode and pulse modulation powering mode. Device power consumption is only 50mW at 500'C in continuous mode, which is up to 100mW lower than that for commercial sensors. Typical response times of 2ms have been measured and so further power saving can be achieved when the sensors are operated in a pulse mode, e.g. 50% duty-cycle at 10Hz. Hence, an overall power saving of 75% could be achieved compared to commercial product. Infrared thermography revealed that a centre hot spot, commonly found with meander style micro-heaters, has been eliminated by the new drive-wheel micro-heater design. The sensitivity of the sensors has also been improved, up to a factor of 4 at 500'C ((60 mV/mm2)/%CH4), by the nanoporous catalyst and by heating it more isothermally. Furthermore, improvements have also been found on the poisoning resistance. Therefore, the potential commercialisation of the micro-calorimeter is very promising.