| Summary: | Wireless Surface Acoustic Wave (SAW) devices were fabricated and tested using planar Lithium Niobate (LiNbO₃) as substrate. The working frequencies were in the 180 MHz and 360 MHz range. Using a network analyser, the devices were interrogated with a wireless range of more than 2 metres. Trials with Electron Beam Lithography (EBL) to fabricate SAW devices working in the 2450 MHz with a calculated feature size of 350 nm are discussed. Charging problems became evident as LiNbO₃ is a strong piezoelectric and pyroelectric material. Various attempts were undertaken to neutralise the charging problems. Further investigation revealed that sputtered Zinc Oxide (ZnO) is a suitable material for attaching SAW devices on irregularly shaped material. DC sputtering was used and several parameters have been optimised to achieve the desired piezoelectric effect. ZnO was sputtered using a magnetron sputtering system with a 75 mm Zn target and a DC sputter power of 250 Watts. Several trials were performed and an optimised material has been prepared under the following conditions: 9 sccm of Oxygen and 6 sccm of Argon were introduced during the process which resulted in a process pressure of 1.2x10⁻² mbar. The coatings have been characterised using Rutherford Backscattering, X-ray diffraction, SEM imaging, and Atomic force microscopy. SAW devices were fabricated and tested on 600 nm thick sputtered ZnO on a Si substrate with a working frequency of 430 MHz. The phase velocity has been calculated as 4300m/s. Non-planar samples have been coated with 500 nm of sputtered ZnO and SAW structures have been fabricated on using EBL. The design frequency is 2450 MHz, with a calculated feature size of 1 µm. The surface roughness however prevented a successful lift-off. AFM imaging confirmed a surface roughness in the order of 20 nm. Ways to improve manufacturability on these samples have been identified.
|
|---|
