High speed multi-frequency impedance analysis of single particles in a microfluidic cytometer using maximum length sequences

A novel impedance spectroscopy technique has been developed for high speed single biological particle analysis. A microfluidic cytometer is used to measure the impedance of single micrometre sized latex particles at high speed across a range of frequencies. The setup uses a technique based on maximu...

Full description

Bibliographic Details
Main Authors: Sun, Tao (Author), Holmes, David (Author), Gawad, Shady (Author), Green, Nicolas G (Author), Morgan, Hywel (Author)
Format: Article
Language:English
Published: 2007.
Subjects:
Online Access:Get fulltext
LEADER 01675 am a22001693u 4500
001 264155
042 |a dc 
100 1 0 |a Sun, Tao  |e author 
700 1 0 |a Holmes, David  |e author 
700 1 0 |a Gawad, Shady  |e author 
700 1 0 |a Green, Nicolas G  |e author 
700 1 0 |a Morgan, Hywel  |e author 
245 0 0 |a High speed multi-frequency impedance analysis of single particles in a microfluidic cytometer using maximum length sequences 
260 |c 2007. 
856 |z Get fulltext  |u https://eprints.soton.ac.uk/264155/1/J41_Sun_Holmes_Gawad_Green_Morgan_Lab_On_A_Chip_2007.pdf 
520 |a A novel impedance spectroscopy technique has been developed for high speed single biological particle analysis. A microfluidic cytometer is used to measure the impedance of single micrometre sized latex particles at high speed across a range of frequencies. The setup uses a technique based on maximum length sequence (MLS) analysis, where the time-dependent response of the system is measured in the time domain and transformed into the impulse response using fast M-sequence transform (FMT). Finally fast Fourier transform (FFT) is applied to the impulse response to give the transfer-function of the system in the frequency domain. It is demonstrated that the MLS technique can give multi-frequency (broad-band) measurement in a short time period (ms). The impedance spectra of polystyrene micro-beads are measured at 512 evenly distributed frequencies over a range from 976.5625 Hz to 500 kHz. The spectral information for each bead is obtained in approximately 1 ms. Good agreement is shown between the MLS data and both circuit simulations and conventional AC single frequency measurements. 
655 7 |a Article