The effect of feed rate on durability and wear of exchangeable cutting inserts during cutting Ni-625
This paper deals with the process of cutting of nickel superalloy and selection of suitable cutting parameters for its easy and effective cutting. The experimental part proposes three exchangeable inserts and determines the effect of feed rate cutting parameter during machining on durability and wea...
Main Authors: | Jana Petrů, Tomáš Zlámal, Robert Čep, Dana Stančeková, Marek Sadílek |
---|---|
Format: | Article |
Language: | English |
Published: |
Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek
2017-01-01
|
Series: | Tehnički Vjesnik |
Subjects: | |
Online Access: | https://hrcak.srce.hr/file/267089 |
Similar Items
-
MECHANISMS OF CUTTING BLADE WEAR AND THEIR INFLUENCE ON CUTTING ABILITY OF THE TOOL DURING MACHINING OF SPECIAL ALLOYS
by: Tomáš Zlámal, et al.
Published: (2016-09-01) -
IMPACT OF CUTTING TOOL GEOMETRY ON THE DYNAMIC LOAD OF SYSTEM IN THE MACHINING PROCESS OF NICKEL ALLOY 625
by: Jiří Hajnyš, et al.
Published: (2016-12-01) -
Effect of the Cutting Tool Geometry on the Tool Wear Resistance When Machining Inconel 625
by: Tomáš Zlámal, et al.
Published: (2017-12-01) -
Effect of the Cutting Tool Geometry on the Tool Wear Resistance when Machining Inconel 625
by: Tomáš Zlámal, et al.
Published: (2018-03-01) -
COMPARATIVE PERFORMANCE OF COATED AND UNCOATED INSERTS DURING INTERMITTENT CUT MILLING OF AISI 4340 STEEL
by: SARAVANAN L., et al.
Published: (2015-05-01)