| Summary: | The planned increase in the mine output from 6.5 to 13.6 million tons per year has set the task of reconstructing a conveyor transport in the eastern inclined shaft of the Raspadskaya mine. The roadway length is 4100 m; the reduced inclination angle is +7°40´. An attempt was made to combine all the positive global practices in one project: the distribution of drive power along the length of a conveyor belt, minimizing the capital cost of implementation. Within the framework of this article, an approach to choosing the speed of a con-veyor belt is discussed, a comparative analysis of the two most com-mon types of intermediate “tripper-type” and “belt-to-belt” drives is given; calculation of a belt conveyor with intermediate “belt-to-belt” drives providing non-reloading conveying in the eastern inclined shaft. Pull force calculations showed that a conveyor belt with four interme-diate “belt-to-belt” drives can be implemented as follows: belt width – 1400 mm, belt speed – 4.0 m/s, mono-material load-carrying belt – PVG-4000, mono-material drive belt – PVG-1400, 2-pulley drive units when mounted on one side: head drive power – 2×1000 = 2000 kW, intermediate drive power – 2×1600 = 3200 kW. Thus, the use of a conveyor belt with four intermediate “belt-to-belt” drives in the in-clined shaft will give the following results: non-reloading transporta-tion over the entire length of the shaft, reducing the additional degra-dation of transported coal due to the exclusion of reloading points, minimizing costs through the use of less durable belts, minimizing costs of sinking an inclined shaft of a smaller cross-section.
|
|---|
